Hinweis
	Ab V10 nicht mehr verwendet (weder installiert noch ausgewertet), Das Markieren von bestimmten Zeilen erfolgt nun mittels der Tabellenvariablen CNSAVOID. Siehe hierzu Abschnitt 7.8.14, „Kennzeichnung zu vermeidender Teile“ in eCATALOGsolutions - Handbuch.

In the DIN, EN and ISO datasheets (as well as other country standards) certain sizes are sometimes considered to be avoided.

Dimensions that should be avoided: Identification in Table view

Via configuration (set for standard parts by CADENAS and may be changed administratively by customer) these sizes may be marked or hidden.

	Tipp
	The following markings complement each other: Parts to replace (see Abschnitt 1.7.3.3, „replace_std.cfg“) Parts to avoid (see Kennzeichnung zu vermeidender Teile) Expired parts (see Abschnitt 5.9.2.12, „Menüpunkt Ablaufdatum (End of Life)“ in eCATALOGsolutions - Handbuch)

The configuration happens in PARTadmin as described below:

Size to be avoided

Block [COMMON] contains the following keys:

A complete definition is contained in each block pair.

First the block, which defines the rule, then the block which is referred by the desired project.

Block [Rule name] contains the following keys:

Example:

[STD-SCREWS-2]
RULE1=D.EQ.3.9

[norm/din/schrauben/blechschrauben/din_6928_c.prj]
RULE1=STD-SCREWS-2