3.1.10.1.2.1. Render mode

3.1.10.1.2. Combination views

3.1.10.1.2.1. Render mode

3.1.10.1.2.1. Render mode

You can change the appearance of the derivatives in the list field under Render mode.

Choose one of the following options in the list field:

Line representation [Line view]:

Line display [Line view]
Lines + shaded representation [Lines + shaded view]:

Lines + shaded display [Lines + shaded view]

Combination of line display and shaded display
Advantage: Visually more appealing than the line display
Shaded view [Shaded View]:

Shaded display [Shaded view]

Here a gridded image is displayed, into a 2-D derivation. The derivation is only created if an export to the CAD system follows.
Advantages:
- Optically more attractive than line display
- Very rapid display, also with complex parts
Note
This render mode is also used to create the 3D data sheet.^[99] See Section 3.1.9.4.4, “Export PDF datasheet ” data sheet. This is where the speed advantage comes into its own.

^[99]This is also the case with PARTcommunity

Prev	Up	Next
3.1.10.1.2. Combination views	Home	3.1.10.1.2.2. Scaling and paper formats