2.3.5.1.2. Key "DistributeMass"

2.3.5.1. Block [CreationOptions(is3d)] - How to setup?

2.3.5.1.2. Key "DistributeMass"

2.3.5.1.2. Key "DistributeMass"

Value range: 0/1

Value = 0:
Do nothing
Value = 1:
- If an assembly mass is given use it else calculate assembly mass from sub parts.
- Calculate total assembly volume from subparts.
- Get all non empty subparts.
- For each non empty subpart:
  - Calculate subpart partial mass = ((subpart volume / volume of all subparts) * assembly mass)
  - Calculate subpart density = subpart partial mass / subpart volume
  - Assign calculated subpart density (instance only)

Prev	Up	Next
2.3.5.1.1. Key "FileName"	Home	2.3.5.1.3. Key "EnhancedPhysicalProperties" - Calculation of Physical Properties