2.2.9.3.1. Key "Material": Alternative methods

2.2.9.3. Background information

2.2.9.3.1. Key "Material": Alternative methods

2.2.9.3.1. Key "Material": Alternative methods

	Note
	The standard declaration is normally completely sufficient. For the sake of completeness, it shall be mentioned that the ERP material column can also be specified directly.

There are two possibilities: Without and with mapping table.

The material name is directly taken from the ERP material column (default is "MAT_NAME") and transferred 1:1.
The mapping table is not used.
```
?GetObject("iface.calcnameservice").start(0)
.Format("<ATTR(MAT_NAME)>").value()
```
The material name is directly taken from the ERP material column (default is "MAT_NAME").
The name determined is then mapped to the CAD system material name using the mapping table (see configuration file [Configuration File] -> "MatMap " block).
```
?context.TranslateStringInGlobalOptionArray("MATMAP","",GetObject("iface.calcnameservice")
.start(0).Format("<ATTR(MAT_NAME)>").value())
```

Prev	Up	Next
2.2.9.3. Background information	Home	2.2.9.3.2. Key "Material": Use input value as Fallback