3.2.12.
General configuration file "ifacecommon.cfg"
3.2.12.10. Block [PSXRewriteCommand]
|  |
| Prev | Next |
Load family table parts (via bulk load)
In order to
family table parts (via bulkload), the following
Block enabled in the CAD-specific configuration file or in ifacecommon.cfg
Will be:[53]
[PSXRewriteCommand] Exec=_META3DHELPER.RewriteNatContainer(_METAOBJ, "CADIDENT", "IDENT-Base-File-Name","NORMIDENT", "NORM-Family-Instance-Name"))
The following distinction must be made:
Case 1: A native part (Plm-Syncro) is to be exported to CAD as a native export.
So Native -> Native --- Use the following configuration in this case:
Exec(is3d)=_META3DHELPER.CreateNatContainer(_METAOBJ, "CADIDENT", "IDENT", "NORMIDENT", "NORM")
Case 1 is only applicable as long as no part families are used.
Case 2 (only available as of 12.13): A real PSOL catalog exists, but instead of creating/downloading this part, an existing NATIVE part is to be used.
So PSOL -> Native --- Use the following configuration in this case:
[PSXRewriteCommand] Exec=_META3DHELPER.RewriteNatContainer(_METAOBJ, "CADIDENT", "IDENT", "NORMIDENT", "NORM")
In all cases, IDENT = filename NORM = part family name
From 12.13 onwards, the case distinction must always be made in this way.