2.1.5. E-mail notification

You make the settings for e-mail notificationsin the configuration file $CADENAS_SETUP/pappserver.cfg.

In the block SendMailTask must be at least the Settings in the key MailHost be set:

MailHost (mandatory): Host name and port of the SMTP server used for sending emails.
username (optional): Username for authentication on the SMTP server
password (optional): Password for authentication on the SMTP server (can be encrypted)
sender (optional): Email address that is used as the sender of the notification. Fallback if not set in a mail task.
receiver (optional): Recipient e-mail address for the notification. Fallback if not set in a mail task.

Module: Module name
Active: Activation/deactivation
TimeTable: OnHealthInfoNotification: The start time for the task is event-based here. The key value is displayed under Run task, when ....
sender
receiver
subject (default): Health Info Notification : Heading in the e-mail
template: preset template

The values entered under sender, receiver and subject are displayed in the e-mail notification.

The following settings must be made so that notifications (error or warning mails) are sent:

Example for block "healthtask:DiskCheck"

SendMailOnError 0/1: Non-existent paths trigger an error mail (if the key is activated)
SendMailOnWarning 0/1: If the disk space is less than the set value, a warning mail is sent (if the key is activated)
SendMailRepeat 0/1:
Paths (default): $CADENAS_DATA
WarnLimitGB:

Example for "DiskCheck": Health Info Notification: DiskCheck

Prev	Up	Next
2.1.4.8. customScript	Home	2.2. Duplicate analysis