3.4.4.2.2. Adjusting sketch accuracy

	Important
If the sketch accuracy between 3Dfindit and Creo does not match, the export could abort with the message "Part could not be created". In order to optimize the adjustment, special settings can be set administratively. See Section 3.3.8.1.2, “ Automatic accuracy search ” in ENTERPRISE 3Dfindit (Professional) - Administration.

Important

If the sketch accuracy between 3Dfindit and Creo does not match, the export could abort with the message "Part could not be created".

In order to optimize the adjustment, special settings can be set administratively.

See Section 3.3.8.1.2, “ Automatic accuracy search ” in ENTERPRISE 3Dfindit (Professional) - Administration.

Prev	Up	Next
3.4.4.2.1. Activation of the 3Dfindit interface in Creo Parametric	Home	3.4.4.2.3. Physical properties from 3Dfindit