Always adjust

PDM_ENOVIA_CONNECTION_TEST_PART_V_ID=PSOPSCV5-CheckConnection
PDM_ENOVIA_CONNECTION_TEST_PART_V_VERSION=---

FileName(is3dPart)=?GetObject("iface.calcnameservice").start(0).Format("<SHORTNAME>").
 reptable("").toFilename("_").value() & ".CATPart"
FileName(isNat,1,1)=?"unimportant"

PDM_ENOVIA_V_ID=?GetObject("iface.calcnameservice").start(0).Format("<SHORTNAME>").
 reptable("").toFilename("_").value()

PDM_ENOVIA_V_ID(isNat)  =?getObject("PARTdataManager.application").viewtable.table.
 selectedrow.rowvalues.getVariableText("ENOVIA_V_ID")

PDM_ENOVIA_V_VERSION=_A_

Changes sometimes needed

PDM_ENOVIA=Yes
PDM_ENOVIA_SAVE=Yes
PDM_ENOVIA_SAVE(isNat)=No
PDM_ENOVIA_DOC_EXISTS=YES
PDM_ENOVIA_ON_LOAD_FAILED=CREATE_IN_LCA
PDM_ENOVIA_ON_LOAD_FAILED(isNat)=STOP
PDM_ENOVIA_ON_NO_CONNECTION=STOP

PLM_usePlmtable2=0

NEVER change

PLM global tobics
PLM_doCheckout=1
PLM_DoCheckin=1
PLM_useVersionInPlmtable2forCheckout=?GetObject("iface.calcnameservice").start(0).Format
 ("<CONFIG(plinkcommon.cfg,common,PLMTABLE_USE_VERSION_FOR_CAD_FILES,0)>").value()
PLM_useGeoFeaturesInPlmtable2forCheckout=1
PLM_checkoutIncludeSubItems=1
PLM_checkinIncludeSubItems=1

Thus far LCA is used without assemblies. Please recheck functionality

 if you turn back SimplifyAssemblies=noSimplifyAssemblies=Yes